company news about Titanium Rod Production Technical Requirements

1. The chemical composition of titanium and titanium alloy rods shall comply with the provisions of GB/T 3620.1. During re-inspection by the purchaser, the allowable deviation of the chemical composition shall comply with the provisions of GB/T 3620.2.

2. The diameter or side length of hot-processed rods and their allowable deviations should comply with the provisions of Table 1.

ti metal bar

3. After hot processing, the bar is turned (ground) and cold rolled. The allowable diameter deviation of the cold drawn bar should comply with the provisions of Table 2.

titaniun metal bar

4. The out-of-roundness of the turned (ground) bar after thermal processing should not be greater than half of its dimensional tolerance.
5. Titanium rod manufacturers believe that the indefinite length of processed rods is 300-6000mm, and that of annealed rods is 300-2000mm. The fixed length or multiple lengths should be within the indefinite length range.